Slightly loosen mounting bolts 1 and adjusting.
Cat 3126 water pump belt adjustment.
Remove the drive belt.
Water pump belt illustration 17 g00426869 exploded view of the drive assembly for a water pump belt 1 mounting bolt 2 square hole 3 adjusting bolt 1.
We use cookies to give you the best possible experience on our website.
Adjust the belt tension with a.
2 install the drive belt.
Slightly loosen mounting bolt 1 and adjusting bolt 3.
I need to tighten the water pump belt on a cat 3126 engine.
If a new belt is installed check the belt adjustment again after 30 minutes of engine operation at rated speed.
I can t see the bolts to adjust.
Water pump belt has a tensioner that can be released with two bolts.
The serpentine belt that was a napa and although about 3 8 inch shorter it worked just fine since it was the replacement one in a crossover.
I can t see the bolts to adjust.
A serpintine read more.
Water pump belt adjustment.
1 use a breaker bar to release the tension on belt tensioner 1.
The water pump belt was a direct replacement.
Exploded view of a water pump belt drive assembly.
I need to tighten the water pump belt on a cat 3126 engine.
Alternator belt loosens with alternator.
Use a breaker bar to release tension on belt tensioner 1.
Safety cat com 3116 and 3126 marine engines maintenance intervals.
1 position belt tensioner 1 on the cylinder block.
Install bolt 2.
No magic answers just keep track of all the bolts washers and spacers.
This video describes and shows how to change a c7 3126 and c9 engine water pump.
Do i have to tear the whole front end apart to get to them.
Procedure to adjust the belt tension.
These pumps are not hard to change but there are a few things to watch fo.
Number one pita for changing belts especially if belt guards and tach drive are installed.
Caterpillar 2020 all rights reserved.
Do i have to tear the whole answered by a verified technician.
I don t know about the fan hub access in the 3126 but the one in my c 7 is held on with about 4 or 6 flat head allen drive screws.