The number of board spaces between the soffit and bottom of the lowest piece of siding at the foundation should be such that the overlap is as per the table.
Cedar clapboard siding installation.
Prime all cut ends and edges of the clapboards.
Installing bevel siding clapboards spacing for the siding should be laid out beforehand.
An inch above the siding s butt edge drive in one 7d nail into each stud.
The average cost to install cedar clapboard siding ranges from 5 to 10 per square foot.
Apply sealant along the corner boards.
Here are a few tips if you plan on installing your own cedar siding.
The cost of removing and disposing of the old siding is not included in this estimate.
How to install cedar weatherboards sort of i love working with cedar it smells good it s easy to handle and it looks awesome.
Cedar siding should be securely nailed to framing members furring members or to blocking between framing members.
Ensure joints meet on studs blocking or furring strips with the nail penetrating solid wood at least 1 1 4 inches.
Clapboard siding is installed horizontally and yields an attractive shadow line which varies with the thickness of siding selected.
When butt jointing siding cut ends at 45 degree angles to form an overlapping joint.
The end grain of all wood products absorbs liquids up to 250.
Bed clapboard ends into it leaving 1 16 inch space along the corner board.
Lumber sizes and spacing for blocking and furring are shown in table 4.
Like all siding materials western red cedar performs best when installed properly on a suitable frame.
Planks are lower priced and cheaper to install than shingles or cedar shakes.
This is particularly important for vertical installation.
Purchase good quality western red cedar clapboards and prime and back prime them or purchase quality primed.
Start with the bottom course using a furring strip to support the lower edge.
The most common size used x 6 is available as solid wood or finger joined both in primed and unprimed.
If clapboard isn t long enough to span a wall splice two together with a 45 degree scarf joint.
Fasten a cedar starter strip the same thickness as the top of the beveled siding all around the house using a tape measure and level to set it level along the bottom of the wall.